Test the GFCIUpdated a year ago
A guide to ensure the GFCI is correctly installed.
Upon powering on Mysa, ensure that your GFCI functions correctly by following the steps below.
If you mistakenly connect the LINE wires to the LOAD terminals, the thermostat faceplate will not illuminate after installation.
How Do I Perform the Test?
- Verify the thermostat's fault light is off. If it is on, press the reset button.
- Turn the heater on to the maximum temperature setting, and wait ten minutes
- Press the test button. If the fault light illuminates and after 5-10 minutes the floor heater cools off, you have installed the thermostat correctly.
- Press the reset button to end the test.
- Repeat this test once a month to ensure proper operation.
Any questions? Reach out to our all-human Customer Experience team!