Device Control Screen

Tap any thermostat tile on the home screen to open its device control screen — this is where you make adjustments to that specific device.

Setpoint

The large number in the center is your setpoint (target temperature). Use the up/down arrows to adjust, or tap the setpoint number directly to open a number selector.

Schedule Status

Below the main controls, you'll see either "Following schedule" or details about a current hold.

Confirming a Change

When you make a change, a blue status bar briefly appears across the top to confirm the command was sent.

Note: if the thermostat is offline, this screen shows when it was last connected and provides reconnect instructions instead.

Bottom Tabs

Tabs at the bottom give you access to that device's Schedule, Usage (energy data, where available), and Settings.

Mode Icon

What you see when you tap the mode icon depends on your specific product (heater type for Baseboard, Heat/Cool/Auto for Central HVAC, etc.) — see your product's Device Control article.

Get Support

Email: support@getmysa.com