Finish setting up your In-Floor thermostat

This article applies to:    
Helpdesk_icons_IF-REV.png    
     

Warning: The installation of high voltage equipment should be performed by a qualified electrician. Please ensure that you comply with local electrical codes and regulations. Improper installation can lead to device failure and even cause a fire. Damage to thermostat due to improper installation is not covered under warranty.

Once the thermostat is wired up, there are just a few more steps to finish installation.

1. Attach the in-floor temperature sensor

Pull the temperature sensor wires through the hole in the back of the Mysa. Then, use a Phillips screwdriver to secure the Mysa to the gang box with the provided screws. Attach the two ends of the sensor wire into the two terminals by gently pressing down on the buttons using the small end of the screwdriver. It doesn't matter which wire attaches to which terminal as long as both are firmly secured.

Screen_Shot_2019-07-26_at_2.30.21_PM.png

2. Connect and secure the front plate of your Mysa. Secure it by tightening the screw. Do not overtighten the screw.

Screen_Shot_2019-07-26_at_2.33.40_PM.png 

3. Turn power on to the Mysa.

Screen_Shot_2019-07-26_at_2.36.34_PM.png

4. Verify the thermostat is on, lights up and displays a triangle.

Screen_Shot_2019-07-26_at_2.37.53_PM.png

Can’t find your answer in our support center? Contact us directly.