How to install Mysa at 120V

This article applies to:    
Helpdesk_icons_IF-REV.png    
     

Warning: The installation of high voltage equipment should be performed by a qualified electrician. Please ensure that you comply with local electrical codes and regulations. Improper installation can lead to device failure and even cause a fire. Damage to thermostat due to improper installation is not covered under warranty.

Floor Sensor

Mysa Sensor
Using an existing sensor

Prior to installation, please be sure to determine the resistance of your thermistor - this can be done using an ohmmeter which will display the resistance eg. 10KΩ. This will be pulled through the back of the in-floor thermostat before finishing the installation!

CAUTION: Please be sure not to connect the thermistor (sensor) wire to any wires on the back of the Mysa device

Before you install you need to identify the cables and wires, and identify the panel and heater connections. Connect your Mysa using the supplied wire nuts.

Screen_Shot_2019-07-26_at_11.17.16_AM.png

The supply and load wires are not interchangeable. If Mysas display doesn't light up after completing installation, you may have wired the supply connections to the load connections or vice-versa. Re-check the wiring and then swap the supply and load wires if necessary.

Screen_Shot_2019-07-26_at_9.12.31_AM.png

For more detailed instructions or different wiring setups, download the Mysa app, tap on 'Install and Support', then 'Install'.

Can’t find your answer in our support center? Contact us directly.